QUICK START
1. Unpack the Red
2. Unpack the MicroSD card (Prepared with RedOS software)
3. Before connecting the power cable Insert the SD Card into the Red (Card reader
see picture)
4. Connect the IEC power cable
Use Red as a Digital Converter (USB to I2S or S/PDIF) follow "Set up the Red in DDC
mode"
Use Red as Streaming Endpoint follow: "Set up the Red as a streaming bridge"
Set up the Red in DDC mode:
1. Power off the Red
2. Unplug LAN cable from the RED
3. Plug the USB cable into the Red and Roon Core
4. Plug the HDMI cable into the Red and your (Holo) DAC.
5. Power On the Red
Following steps are for Roon setup only
6. The Red should be available in Roon Core in Audio Setup
7. Enable the Red on your Roon Core Audio Setup
8. Play music from Roon to the Red
Set up the Red as a streaming bridge
Note: Please make sure you do not change settings in RedOS if you don’t know
what you’re doing. USB redirector is configured correctly and no need to make
changes to its config normally.
When LAN cable is connected (and USB-IN not connected), the RED will act as a
network bridge.
1. Power off the Red
2. Unplug the USB cable from the RED
3. Connect the LAN cable into the Red (and make sure the SD Card is
properly inserted)
4. Plug the HDMI cable into the Red and your Holo DAC.
5. Power On the Red
Following steps are for Roon setup only
To Next Page
Loading...
Need help?
General