14
5 | MOVEMENT MODULE
MOVEMENT
Warp and expand your sound with modulation effects inspired
by classic studio recording gear and techniques, ranging from
subtle to pronounced, steady to wobbly.
The yellow RATE & AMOUNT knobs control the selected effect.
DOUBLER: Stereo double tracking effect that reproduces the sound of
overdubbing a part multiple times. Sounds range from tight doubling to
short slap-back delay.
RATE: sets the doubling time range from short to long.
AMOUNT: mixes in more doubling as it is increased.
DRIFT: introduces and increases intensity of random momentary pitch
shifts.
VIBRATO: Lush pitch modulation that can range from classic sine wave
vibrato to tapelike random warbles.
RATE: sets the frequency of the pitch modulation.
AMOUNT: adjusts the modulation depth.
DRIFT: increases the stereo width of the effect and introduces a random
modulation waveform that evokes tape warble and instability.
EFFECTS
15
PHASER: Vintage-voiced classic phaser effects that range from swirling
hypnotic sweeps to pulsing vibrato-like undulation.
RATE: sets the phase-shifting frequency.
AMOUNT: adjusts the modulation intensity and introduces additional phase
shifting stages (ranging from 2-stage to 12-stage). This allows for many
different phase shifting styles across the travel of the knob, so experiment
to find the sound you like the best.
DRIFT: adds randomness to the phase-shifting waveform.
TREMOLO: Colorful, pulsing, amplitude modulation that can go from a
classic guitar amp shimmer to a hard, square-wave chop.
RATE: sets the amplitude modulation frequency.
AMOUNT: sets the tremolo depth, from soft flutter to choppy rhythm.
DRIFT: introduces randomness, variation, and instability into the tremolo
effect as DRIFT increases.
PITCH: Pitch shifting from -1 octave to +1 octave. Use DRIFT to add a
colorfully expressive lo-fi grit, or try automating the sweep or the pitch with
GESTURE for maximum enjoyment.
RATE: determines pitch of effect. No pitch shifting is applied in the center,
-1 Octave when fully left, and +1 Octave when fully right—with gliding travel
through the pitch range in between.
AMOUNT: determines the mix of the pitch-shifted signal; 100% wet signal
when fully clockwise.
DRIFT: lowers the resolution of the pitch shifter in a pleasing, lo-fi manner.
Adds instability as DRIFT increases. Can be used in the center position,
even if no pitch shifting is applied, to add a little extra personality to your
signal.
EFFECT VOL adjusts the output volume of the Movement module.
To Next Page
