Holtek HT48R70A-1 - Chapter 6 Quick Start; Step 1 - Create a New Project; Step 2 - Add Source Program Files to the Project; Step 3 - Build the Project

Chapter 6
Quick Start
This chapter gives a brief description of using HT-IDE3000 to develop an application project.
Step 1 - Create a New Project
·
Click on Project menu and select New command
·
Enter your project name and select an MCU from the combo box
·
Click OK button and the system will ask you to setup the configuration options
·
Setup all configuration options and click Save button
Step 2 - Add Source Program Files to the Project
· Create your source files by using File/New command
· Write your program and save them with a file name, say TEST.ASM
· Click on Project menu and select Edit command
· An Edit Project dialog will ask you to add/delete files to/from the project
· Select a source file name, say TEST.ASM, and click Add button
· Click OK button after you setup all files in the project
Step 3 - Build the Project
·
Click on Project menu and select Build command
·
The system will assemble/compile all source files in the project
-
If there are some errors in the programs, double click on the error message line and the sys
-
tem will prompt you the position where the error happened.
-
If all the program files are error free, the system will create a Task file and download to the
HT-ICE for debug.
·
You may repeat this step before you finish debugging your programs
Step 4 - Programming the OTP Device
·
Build the project for creating the .OTP file
·
Click on Tools menu and select the Writer command to program the OTP devices
Chapter 6 Quick Start
141
6