HOLYKELL UF2000 Series User Manual

Defines the components of ultrasonic flow and heat meters.

Lists and illustrates various types of converter models available.

Details different types of flow and temperature transducers offered.

Ensures all ordered components are present and matched correctly for sets.

Illustrates flow meter setup in separated mounting configurations.

Shows flow meter installation in fixed mounting arrangements.

Depicts flow meter configurations using module types.

Instructions for installing and wiring UF2000B, UF2000SW, UF2000SD converters.

Guidelines for installing and wiring UF2000F converters using fix mounting.

Details on installing and wiring module type converters.

Introduction to clamp-on transducers, their features, and wiring.

Introduction to insertion type transducers, their components, and wiring.

Introduction to inline type transducers, their installation, and wiring.

Describes the LCD display and the 16-key and 4-key operating keyboards.

Explains how to navigate the user interface and operate the flow meter.

Comprehensive list of menu parameters for configuration and operation.

Guides on inputting parameters like diameter, material, and transducer type for accurate measurement.

Factors to consider for selecting optimal installation locations for transducers.

Procedures and methods for installing clamp-on type transducers.

Steps and methods for installing insertion type transducers.

Procedures for installing inline type transducers in pipelines.

Verifies signal strength and quality of upstream/downstream transducers.

Checks the ratio between measured and theoretical transmission times.

Covers commonly used menus, cable length, and environmental requirements.