< GENERAL INFORMATION>
ettre le foncrionnemenr. mauvais foncrionnement de rappareil.
Cet appareil nurneriquie de la c/asse 8 est conforme
a
ta norme
NMB-003 du Canada.
CAN NMB-3 IS)
RF Exposure
Radiation Exposure Statement:
This
equipment
complies
with Ie
radiation exposure limits set
forth for an uncontrolled environment. This
equipment
should
be installed and operated with
minimum
distance
20cm
between the radiator & your body
Declaration d'expositicn aux radiations
Cet equipement
est conforme aux
limites
d'exposition aux
rayonnements
Ie
etaones pour un
environnement
non
conrrole, Cet equpement doit etre
mstaue et uti/is€:>avec un
minimum de 20 em de distance entre lasource de rayonnement
et votre corps
HOW TO RECYCLETHIS PRODUCT
This symbol on the product
or
its documentation indicates that it
must not be disposed of with household waste
Uncontrolled waste disposal may harm (he environment or human
health.
Please separate your device from other types of waste to recycle it
responsibly.
-21-
< GENERAL INFORMATION>
This will help ro foster the sustainable re-use of material resources.
We invite you to contact your retailer or inquire at your local town
hallto find out where and how the drone can be recycled.
:a-
SATIERYWARNING _
I.
Failure to follow all the instructions may result in serious injury,
irreparable damage to the battery and may cause a fire, smoke or
explosion.
2.
Always check the battery's condition before charging or using it.
3. Replace the battery if it has been dropped.
or
in case of adaur.
overheating, discolouration, deformation or leakage.
4.
Never use anything other than the approval LiPo charger the
battery. Always use a balancing charger for LiPa cells or a lIPo cell
balancer. It is recommended that you do not to use any other
charger than the one provided with the product.
S. The battery temperature must never exceed
60·q
140·FJ
otherwise the battery could be damaged or ignite.
6. Never charger on a ftammable surface. near flammable products
or inside a vehicle/perferably place the battery In a non-ftammable
and nonconductive container}.
7. Never leave rhe battery unattended during the charging
process.
Never disassemble or modify the housing's wiring, or puncture the
cells. Nways ensure that the charger output voltage corresponds to
the volrage of the battery. Do not short circuit the batteries.
-22-
To Next Page
Loading...
