What to do if my HOLZMANN MASINEN Lathe machine does not start?
If your HOLZMANN MASCHINEN Lathe machine does not start, check all electrical connections, change the fuse, and activate the contactor. If the issue persists, consider replacing the cable.
Why is my HOLZMANN MASCHINEN Lathe vibrating so strongly?
If your HOLZMANN MASCHINEN Lathe is vibrating strongly, try to reconstitute it and ensure that all fixing screws are tightened.
What to do if my HOLZMANN MASCHINEN ED 300FD Lathe does not come up to speed?
If the HOLZMANN MASCHINEN Lathe machine does not come up to speed, exchange it on an optional extension cable (refer to the wiring box cover for correct wiring). If problems persist, contact an electrician.
How to extend turning tool life on HOLZMANN MASCHINEN ED 300FD?
To extend the life of your turning tool on the HOLZMANN MASCHINEN Lathe, remove any cast skin before you break, select a lower cutting speed, lower the delivery (finishing allowance not more than 0.5 mm), and ensure more cooling.
What to do if cutting breaks out on HOLZMANN MASCHINEN ED 300FD?
If cutting breaks out while using the HOLZMANN MASCHINEN Lathe, choose a greater wedge angle and ensure uniform cooling. Also, adjust the play in the spindle bearings, and if necessary, replace the tapered roller bearings.
General| Model | ED 300FD |
|---|---|
| Swing Over Bed | 300 mm |
| Center Height | 150 mm |
| Bed Width | 180 mm |
| Spindle Bore | 38 mm |
| Voltage | 230 V |
To Next Page
