How to extend the tool life of my HOLZMANN MASCHINEN Lathe tool?
If your HOLZMANN MASCHINEN Lathe tool has a short tool life, try breaking the casting skin beforehand. You might also want to choose a lower cutting speed, lower the infeed (finishing allowance) to not more than 0.5 mm, or use more cooling.
What to do if the cutting edge breaks out on my HOLZMANN MASCHINEN ED400FDDIG?
If the cutting edge of your HOLZMANN MASCHINEN Lathe is breaking out, select a larger wedge angle and ensure uniform cooling. You may also need to adjust play in the spindle bearing or replace the tapered roller bearing if necessary.
How to troubleshoot a HOLZMANN MASCHINEN Lathe that does not start?
If your HOLZMANN MASCHINEN Lathe machine does not start, check all electrical connections. Also, try changing the fuse and activating the contactor. If that doesn't work, replace the cable or check the spindle protection/gearbox cover.
What to do if my HOLZMANN MASCHINEN ED400FDDIG does not reach full speed?
To address this issue with your HOLZMANN MASCHINEN Lathe, try exchanging to a suitable extension cable and check the switch box cover for correct wiring. If problems persist, contact an electrician.
Identifies and explains machine controls and displays.
Provides specifications like voltage, power, dimensions.
Specifies authorized operations and limitations.
Essential precautions for safe operation.
Identifies potential dangers and injury risks.
Securing the cutting tool in the holder.
General| Model | ED400FDDIG |
|---|---|
| Type | Lathe |
| Swing Over Bed | 400 mm |
| Distance Between Centers | 1000 mm |
| Center Height | 200 mm |
| Spindle Bore | 38 mm |
| Spindle Taper | MT5 |
| Tailstock Taper | MT3 |
| Number of Speeds | Variable |
| Motor Power | 1.5 kW |
| Voltage | 400 V |
| Inch Thread | 4-60 TPI |
To Next Page
