5.4 SETTINGS
5.4.1. Start-up and Shutdown
Press POWER to turn the unit on.
The unit runs in in FAN as default.
Press MODE button to select the desired operation mode.
Press POWER again to turn off the power.
5.4.2. Operation mode
The unit has five operation modes: Cool, heat, fan, dry,sleep.
A.
Cooling your room
Select the cool mode to lower the temperature in your room.
Press MODE button repeatedly until the LED of COOL operation lights up.
Press ADD/MINUS button to adjust the temperature which is displayed
on the screen. The temperature can be set between 16℃ and 32℃.
Press SPEED button repeatedly until the desired fan speed indicator lights
up.
To control the direction of the air flow horizontally, please adjust the
inner louver by hand.
Note： The air conditioner stops if the room temperature is lower than
selected temperature.
B.
Heating your room(Optional for Heating Function
Unit only)
Press MODE button repeatedly until the LED of HEAT operation lights up.
Press ADD/MINUS button to set the temperature higher than the room
temperature. The fan speed can also be set.
Note: The drainage hose should be attached to the unit for continuous
operating.
C.
Ventilating your room
Press MODE button repeatedly until the LED of FAN operation lights up.
In ventilation mode the room air is circulated, but not cooled.
Press SPEED button repeatedly to select the fan speed as desired.
To Next Page
Loading...
Need help?
General
