Home Decorators Collection JUNEDALE - Assembly - Standard Ceiling Mount; Preparing for Mounting; Routing the Wires

8
Assembly - Standard Ceiling Mount
Preparing for mounting
□ Remove the magnetic canopy bottom cover (DD) from the
canopy (B) by pulling it off.
□ Loosen the two canopy screws (CC) located in the bottom of
the mounting bracket (A).
□ Turn the mounting bracket (A) counterclockwise and lift it up to
remove the mounting bracket from the canopy (B).
1
Routing the wires
□ Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (DD).
□ Make sure the opening of the canopy (B) is on top and insert
the ball/downrod (C) through the canopy (B).
□ Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
2
A
CC
B
DD
B
C
D
DD
E