To Next PageTo Next PageWhat to do if my Home Decorators Collection MAKENNA Fan will not start?
If your Home Decorators Collection Fan won't start, check the main and branch circuit fuses or breakers. Also, check the line wire connections to the fan and switch wire connections in the switch housing.
How to fix Home Decorators Collection MAKENNA Fan wobble?
To fix a wobbling Home Decorators Collection Fan, start by checking that all blade and blade arm screws are secure. Unequal blade levels often cause wobble. To check this, measure from a point on the center of each blade to a point on the ceiling above the blade tip; any deviation should be within 1/8 inch. Run the fan for ten minutes; if wobbling continues, contact Customer Service for a free balancing kit.
Why is my Home Decorators Collection MAKENNA so noisy?
If your Home Decorators Collection Fan is noisy, make sure all motor housing screws are snug. Also, check that the screws attaching the fan blade bracket to the motor hub are tight. Ensure wire nut connections aren't rattling against each other or the switch housing's interior wall. Allow a 24-hour “breaking in” period, as most new fan noises disappear then. If using a light kit, tighten the glassware screws and ensure the light bulbs are secure. The canopy should also be a short distance from, but not touching, the ceiling. Lastly, confirm your outlet box is secure and rubber isolator pads were used between the mounting plate and outlet box.
General| Indoor/Outdoor | Indoor |
|---|---|
| Number of Blades | 5 |
| Fan diameter (in.) | 52 |
| Light Included | Yes |
| Reversible Motor | Yes |
| Light Type | LED |
| Blade Span | 52 |
| Warranty | Lifetime |
Explains different methods for securely mounting the fan to the ceiling outlet box.
Instructions for securely mounting the fan's bracket to the ceiling electrical box.
Detailed guide on connecting the fan's wires to the household electrical wiring.
Final steps to secure the fan motor assembly to the mounting bracket using canopy screws.
Explains how to use the pull chain for fan speed and the slide switch for direction.
