Home Protector 72268 - Electrical Hazards

6
The camera and accessories may not be used by children or persons with a limited ability of
operang equipment. The camera may not be used by persons (including children) with limited
physical, sensory or mental capacies or limited experience and/or knowledge. The camera, the
receiver and mains adapter may only be used by persons that are physically or mentally able to
operate the equipment safely, unless they are supervised by a person responsible for their safety
or have been instructed by this person as to how to use the equipment. Children should be
supervised to ensure that they are not playing with the equipment.
1. Please keep the glass surface of the camera clean to unsure its correct operaon. DO NOT
use abrasive cleaning agents, alcohol or similar. DO NOT use sharp edged tools, or similar
to remove debris from the device.
2. Choose a suitable locaon for the security device, ensuring that it is posioned away from
sources of strong light. This will aect the image quality and may cause damage to the
units CCD (Charge-coupled Device).
3. Do not touch the CCD sensor directly with your nger. If necessary use so damp cloth to
wipe o the dust.
4. If the product becomes damaged DO NOT use. Contact the number provided on your
warranty card or a qualied electrician if the item requires repairing. Do not open the
camera as this will void any warranty.
Electrical hazard
Switch o camera if a foreign body or liquid has entered the camera. Wait unl completely
dry, there is danger of re and electrocuon.
Switch o if camera or receiver has been dropped or if housing is damaged, there is danger of
re and electrocuon.
The camera and its components may not be dismantled, modied or repaired, there is danger
of re and electrocuon.
Only use the supplied power supplies or power supplies with the same specicaons. Only
connect power supplies to the mains voltage specied on the rang plate.
Do not use power supply or output cable if damaged. Replace with same type of power
supply.
Check that all used mains sockets are always accessible so that the power supply can be
quickly interrupted when necessary. The device is disconnected from the mains by pulling out
the plug from the mains socket.