Home HME020003N - Securing Installation and Storm Window Handling; Secure Accordion Panels; Install Support Bracket

9
B. Slide the free end “ ” section of the panel directly
into the cabinet as shown in Fig. 2. Slide the panel
down. Be sure to leave enough space to slip the top
and bottom of the frame into the rails on the cabinet.
C. Once the panel has been installed on the side of
the cabinet, make sure it sits securely inside the
frame channel by making slight adjustments. Slide
the top and bottom ends of the frame into the top
and bottom rails of the cabinet. (Fig.3).
D. Slide the panel all the way in and repeat on the
other side.
INSTALLATION INSTRUCTIONS
SECURE THE ACCORDION PANELS
INSTALL SUPPORT BRACKET
4
5
Fig. 2
Fig. 5
Fig. 6
Fig. 7
Fig. 3
Fig. 4
“ ” section”
Top Rail
Bottom Rail
Fig.3
NOTE: If storm window blocks AC, see Fig. 11.
NOTE: Check that air conditioner is tilted back about
5/8” to 3/4” (tilted about 3
O
to 4
O
downward to the
outside). After proper installation, condensate should
not drain from the overow drain hole during normal
use, correct the slope otherwise.
A. Keep a rm grip on the air conditioner, carefully
place the unit into the window opening so the
bottom of the air conditioner frame is against the
window sill (Fig.5). Carefully close the window
behind the top rail of the unit.
A.Place the frame lock between the frame
extensions and the window sill as shown (Fig.7).
Drive 3/4” or 1/2” locking screws through the
frame lock and into the sill.
NOTE: To prevent window sill from splitting,
drill 1/8” pilot holes before driving screws.
B. Extend the side panels out against the window
frame (Fig.6).
Measure from the cabinet edge
Wooden Windows
OUTSIDE
INSIDE
About 5/8” to 3/4”
window frame