Home HME020279N - Operating Instructions; Control Panel Overview; Basic Operation Modes

12
Operating Instructions
CONTROL PANEL
1 2 3 4
5 6 78
ABCDEF G
POWERTIMERPUMP DECREASEINCREASE
FILTER
Clean Turbo Pump
RH% Lock
Timer
Full
Cont.
TURBO
1. Clean Filter indicator A. On/Off button
2. Turbo indicator B. Timer button
3. Display screen C. Decrease button
4. Lock indicator D. Increase button
5. Timer indicator E. Fan Speed button
6. Full bucket indicator F. Filter Reset button
7. Continuous indicator G. Pump button
8. Pump indicator
Power on
Insert the plug in the socket, the unit goes to stand-by, and the screen display as the g shown:
On / Off Buon
Press this button to turn on or shut down the unit.
Decrease / Increase buon
• Press INCREASE / DECREASE button to select the indoor humidity level you expect to achieve. You
can also use the two button to set a timer.
• The humidity adjustable range is 35%RH-80%RH. The screen will display the setting humidity and
turn to display the ambient humidity after a few seconds.
• If the ambient humidity is lower than setting humidity, the compressor will stop running. After a few
minutes, the fan will stop running.
• Press the DECREASE button until “
” is displayed on the screen. The "Cont." will light up, then the
unit will run continuously.
Turbo buon
Press the TURBO button to select the high speed or low speed of fan. When high speed is selected, the
TURBO indicator will light up.