16
Cleaning and Maintenance
Before any cleaning or maintenance, turn off the appliance and unplug it from the wall socket.
• Wipe the cabinet of the unit with a slightly damp cloth and then dry it naturally or wipe it dry.
• Never wash the unit with water, it could be dangerous.
• Never use petrol, alcohol or solvents to clean the unit.
• Never spray insecticide liquids or similar to the unit.
• Clean the bucket with water every two weeks.
CLEANING THE FILTER
• To keep your appliance working efciently, clean the lter every week of operation.
• When the lter needs to be cleaned, the Clean indicator will light up (after 250hours of use). Remove
the lter from the back of the unit.
• Remove the lter refer to below picture.
• Use a vacuum cleaner to remove dust from the lter. If the lter is very dirty, immerse it in warm
water and rinse it a number of times. The water temperature should not be higher than 104°F. After
washing, leave the lter to dry.
• Once the lter drys completely, place the lter back in the unit and press the FILTER button to reset
the Clean indicator.
Caution:
• Do not operate the appliance without the lter in place.
• When removing or re-installing the lter, be careful to avoid possible cuts, and do not contact the
metal parts of the appliance, which will result in personal injury.
END OF SEASON OPERATIONS
- Unplug the unit from the outlet, empty the bucket and remove the drain cap.
- Run off all water left inside the appliance. When all the water has been drained, put the cap back in place.
- Clean the lter and dry it thoroughly before putting back.
- Cover the appliance to avoid dust accumulation.
- Store the appliance upright in a dry location.
START OF SEASON CHECKS
Make sure the power cable and plug are undamaged and the earth system is efcient. Follow the
installation instructions precisely.
To Next Page
Loading...
