EasyManua.ls Logo

Home HME020279N - Bucket Management and Draining

Home HME020279N
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
Operating Instructions
Note:
Hold the bucket with both hands when emptying the bucket.
The unit will not run again until the bucket is emptied and properly placed back inside the unit.
When the bucket is full or removed from the unit, the compressor will turn off but the fan will
continue to run for a few minutes. This is completely normal. The unit will not be removing moisture
from the air at this time.
During operation, it is normal for the unit to exhaust warm air from the top of the unit.
Caution:
Do not place the bucket on the oor when it is full as the bottom of the bucket is uneven and may spill water.
Continuous drain
Connect the drain pipe on the back of unit, the unit can continuous run without cleaning the bucket.
1. Put the unit on level oor, unscrew the cap on the back of unit.
2. Install the drain connector and the gasket.
3. Install the garden hose (which has an outer diameter of 1.0625 inches and a pitch of 11.5 TPI) to the
unit. Make sure the connection is tight and there is no leaking.
4. Press POWER button to run the unit.
Note:
If no need for continuous drain, install the cap on the drain hole on the back of the unit, then the
water will ow into the bucket.
If the drain pipe is installed incorrectly, the water cannot drain from the pipe.
Note:
Make sure the unit is put on level ground and the drain pipe is installed correctly, otherwise the
bucket will be full of water, and the unit stop run.
Make sure the bucket is installed correctly.

Related product manuals