20 21
REMOTE CONTROL
HOW TO USE THE ADVANCED FUNCTIONS
REMOTE CONTROL
SETTING THE TIMER FUNCTION
Example 2: Setting the unit to turn on after 6 hours, work for 2 hours, then turn off automatically. Follow the steps below:
NOTE:
-The button design might be different from the actual one you purchased.
-All the functions described are based on the unit. If the unit is designed without a particular feature,
nothing will happen when pressing the relative button on the remote control.
-When there are differences between the remote control illustration the remote control illustration and the USER MANUAL on function
description, the description on the USER MANUAL should prevail.
-The device complies with the local and national regulations. local and national regulations.
NMB-3(B). In the USA, this device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
-This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on
could void user authority to operate the equipment.
SLEEP Function
Used to decrease energy use while
you sleep.
Note: The SLEEP function is not
available in FAN or DRY mode.
SHORTCUT function
Used to restore the current
settings or resume previous
settings.
Press this button when the
remote control is on and the
system will automatically revert
back to the previous settings,
including operating mode,
setting temperature, fan speed
and sleep feature (if activated).
If pressed for more than 2
seconds, the system will
automatically restore the
current operational settings,
including operating mode,
setting temperature, fan speed,
and sleep feature (if activated).
SWING Function
Used to stop or start the air outlet
door movement and set the desired
pressing for more than 2 seconds,
the air outlet door auto swing
feature will be activated.
Seing both TIMER ON and TIMER OFF at the same time
Keep in mind that the time periods you set for both functions refer to hours
after the current time.
Example 1: If the current time is 1:00 PM, and you want the unit to turn on
automatically at 7:00 PM, work for 2 hours, then automatically turn off at
9:00 PM.
To Next Page
Loading...
