HoMedics BPA-200 User Manual (English)

Questions and Answers:

N
Nicolas MannJul 29, 2025
What to do if HoMedics BPA-200 Blood Pressure Monitor shows EE error?
- B
  billychandlerJul 29, 2025
  If your HoMedics Blood Pressure Monitor displays the EE error symbol or the blood pressure value appears excessively low or high, it could be due to incorrect cuff placement. Ensure the cuff is wrapped properly and positioned correctly. Also, avoid talking or moving during the measurement and keep your arm steady. Shaking your arm with the cuff on can also cause the error.
A
Annette ParkerAug 3, 2025
Why HoMedics BPA-200 does not turn on?
- J
  Jeffrey HuberAug 3, 2025
  If your HoMedics Blood Pressure Monitor fails to power on when you press the START/STOP button, it could be due to drained batteries. Replace them with four new AA alkaline batteries. Alternatively, the batteries might be incorrectly positioned. Ensure you re-insert them with the correct polarities.
M
Michael BryantAug 8, 2025
What does E1 error mean on HoMedics BPA-200?
- E
  elizabeth52Aug 8, 2025
  If your HoMedics Blood Pressure Monitor displays the E1 error symbol, it indicates an air circuit abnormality. Check the cuff connection to ensure the cuff tube is correctly plugged into the monitor, then measure again.
B
Brian MarshallAug 13, 2025
What does E2 error mean on HoMedics Blood Pressure Monitor?
- K
  Keith WoodAug 13, 2025
  If your HoMedics Blood Pressure Monitor displays the E2 error symbol, it means the inflation pressure exceeded 300 mmHg. Switch the unit off, and then measure again.
E
edwardstevensAug 18, 2025
What does Er error mean on HoMedics BPA-200?
- S
  Sarah NelsonAug 18, 2025
  If your HoMedics Blood Pressure Monitor displays the Er error symbol, it means the measurement result exceeds the measurement range. Make sure you do not move during measurement, and measure again. Shaking your arm with the cuff on can also cause the error.
G
gilesjamesAug 23, 2025
How to fix E3 error on HoMedics BPA-200 Blood Pressure Monitor?
- N
  nwarnerAug 23, 2025
  If your HoMedics Blood Pressure Monitor shows the E3 error symbol, it indicates a data error. To resolve this, remove and reload the batteries.

HoMedics BPA-200 Specifications

General

Measurement Method	Oscillometric
Memory Function	Yes
User Profiles	2
Irregular Heartbeat Detection	Yes
Device Type	Upper Arm Blood Pressure Monitor
Display Type	LCD
Memory	60 readings per user
Power Source	4 x AA batteries
Pulse Rate Range	40-200 beats per minute