Homelite HBHT2655 - User Manual

Questions and Answers

M
Megan AlexanderAug 10, 2025
What to do if my Homelite HBHT2655 Trimmer engine does not reach full speed and emits excessive smoke?
- P
  Pam SanchezAug 10, 2025
  If your Homelite Trimmer engine doesn't reach full speed and emits excessive smoke, the lubricant and fuel mixture might be incorrect. Use fresh fuel and the correct 2-stroke lubricant mix.
T
Theresa CookeAug 15, 2025
Why does my Homelite Trimmer start but not accelerate?
- C
  coreybakerAug 15, 2025
  Your Homelite Trimmer engine may require approximately three minutes to warm up. Allow the engine to completely warm up. If the engine does not accelerate after three minutes, contact a servicing dealer.
D
dsheltonAug 22, 2025
What causes a Homelite HBHT2655 Trimmer engine to start but only run at high speed at half choke?
- E
  eduardorussellAug 22, 2025
  If your Homelite Trimmer engine starts but only runs at high speed at half choke, the carburetor may require adjustment. Contact a servicing dealer.
S
samantha46Aug 27, 2025
What to do if Homelite HBHT2655 starts, runs, and accelerates but does not idle?
- M
  Mary PierceAug 28, 2025
  If your Homelite Trimmer starts, runs, and accelerates but does not idle, the idle speed screw on the carburettor may require adjustment. Contact a servicing dealer.
S
sarah35Nov 3, 2025
Why won't my Homelite HBHT2655 start?
- P
  patricia25Nov 3, 2025
  There are several reasons why your Homelite Trimmer might not start. It could be due to no spark. To check for spark, remove the spark plug, reattach the spark plug cap, and lay the spark plug on the metal cylinder. Pull the starter rope and watch for a spark at the spark plug tip. If there's no spark, repeat the test with a new spark plug. Another reason could be no fuel. Push the primer bulb until it's full of fuel. If it doesn't fill, the primary fuel delivery system might be blocked. Also, the engine may be flooded. Remove the spark plug, turn the engine to aim the spark plug hole at the ground, adjust the choke lever to the position, and pull the starter cord 10-15 times to clear excess fuel. Clean and reinstall the spark plug. Clean up any spilled fuel and move at least 9 meters away...