28
1
2
4
1
2
3
2
4
1
3
REPLACING THE SPARK PLUG
1. To stop the engine, toggle either the
blower or vacuum switch to the “STOP”
position.
2. Disconnect the lead wire from the
spark plug. Using a socket wrench with
an extension and spark plug socket,
loosen the spark plug by turning it
counterclockwise.
3. Remove the old spark plug and dispose
properly.
4. Using the socket wrench, install the
new spark plug and tighten by turning it
clockwise. Connect the lead wire to the
spark plug.
To Next Page
Loading...
Need help?
General