Page 5
PULL
PUSH
Fig. 1
PUSH AND PULL
See Figure 1.
The reaction force is always opposite to the direction the
chain is moving. Thus, the operator must be ready to
control the PULL when cutting on the bottom edge of the
bar and the PUSH when cutting along the top edge.
MAINTENANCE PRECAUTIONS
Never operate a chain saw that is damaged, improperly
adjusted, or is not completely and securely assembled. Be
sure that the saw chain stops moving when the throttle
control trigger is released. If the saw chain moves at idle
speed, the carburetor may need adjusting. Refer to
“Operation” later in this manual. If the saw chain still
moves at idle speed after adjustment has been made,
contact a Homelite Service Center for adjustment and
discontinue use until the repair is made.
WARNING:
All chain saw service, other than items in the operator's
manual maintenance instructions, should be performed
by competent chain saw service personnel. If improper
tools are used to remove the flywheel or clutch, or if an
improper tool is used to hold the flywheel in order to
remove the clutch, structural damage to the flywheel
could occur which could subsequently cause the
flywheel to burst and serious injury could result.
KICKBACK
Kickback is a dangerous reaction that can lead to serious
injury. Do not rely only on the safety devices provided with
your saw. As a chain saw user, you must take special
safety precautions to help keep your cutting jobs free from
accident or injury.
Note: See the "Operation" section later in this manual for
added information on kickback and how to avoid serious
personal injury.
Note: Your chain saw has been fully factory tested. It is
normal to find some slight oil residue on the saw.
SPECIFIC SAFETY RULES
To Next Page
Loading...
Need help?
General