---
MAINTENANCE
A WARNING:
A WARNING:
When servicing, use only identical replacement parts.
Always protect hands by wearing heavy gloves and/or
Use
of
any other parts may create a hazard
or
cause
wrapping the cutting edges
of
the blade with rags and
product damage.
other material when performing blade maintenance.
Failure to heed this warning so could
result
in
serious
personal injury.
A WARNING:
.
Always wear safety goggles or safety glasses with side
A
WARNING:
shields during
power
tool operation
or
when blowing
dust.
If
environment is dusty, also wear a dust mask.
Before performing any maintenance, make sure the
battery
is
removed from the battery compartment and the
GENERAL MAINTENANCE
switch key is removed. Failure
to
heed this warning could
result
in
serious personal Injury.
Avoid using solvents when cleaning plastic parts.
Most
plastics are susceptible to damage from various types
of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt. dust, oil, grease,
etc
.
REPLACING THE CUTTING BLADE
See
Figures
9 -
10
.
·A WARNING:
NOTE:
Only use identical replacement blades.
Do not at any time let brake fluids, gasoline, petroleum-
• Stop the motor and remove the switch
key.
Allow blade
based products, penetrating oils, etc., come in contact
to come to a complete stop. Remove battery from the
with plastic parts. Chemicals can damage, weaken,
or
battery compartment.
destroy plastic which may result
in
.serious personal
injury.
• Tum the mower on its side.
• Wedge a block
of
wood between the blade and mower
Periodically check all nuts and bolts for proper tightness to
deck to prevent the blade from turning.
ensure safe operation
of
the mower.
• Loosen the blade nut using a
15
mm
wrench
or
socket
Remove any buildup
of
grass and leaves on
or
around the
(not provided).
motor
cover. Wipe the mower clean with a dry cloth occa-
• Remove the blade nut, spacer, biade insulator, and
sionally. Do not use water.
blade.
LUBRICATION
• Make certain the fan assembly is pushed completely
against the
motor
shaft.
All
of
the bearings
In
this product are lubricated with a suf-
ficient amount of high grade lubricant for the life
of
the unit
under normal operating conditions. Therefore, no further
bearing lubrication
is required.
• Lubricate the height adjustment lever and related hardware
with light oil.
• Remove the wheels and lubricate the surface
of
the axle
bolt and the inner surface
of
the wheel wi
th
light oil.
•
Remove
the
blade
and
blade
hub
assembly
and
lubricate the
motor
shaft with light oil or engine oil. See
Replacing
the
Cutting
Blade
for instructions on remov-
ing the blade.
Page 14
---
-- .
__
....
-
To Next Page
Loading...
Need help?
General
