MAINTENANCE
ENGINE MAINTENANCE
Use the following maintenance section to keep your unit in
good operating condition. All the maintenance information for
the engine is in the "Engine Operator's Manual". Before you
start the engine, read this manual.
HOW TO CHANGE THE OIL
1. Shut off engine and wait for it to cool.
2. Disconnect spark plug wire from the spark plug.
3. Remove the oil drain plug. (See Figure 11)
4. Drain all the engine oil into a flat pan.
5. Install the oil drain plug. Make sure fhe oil drain plug is tight.
6. Remove the dipstick.
7. Fill the engine crankcase. DO NOT OVERFILL. Refer
to Engine Preparation section for instructions on filling oil
to proper level.
8. Connect the spark plug wire to the spark plug.
A WARNING
Before you inspect, clean, or service the trimmer, stop
the engine. Make sure that all moving parts have
stopped. Disconnect the wire from the spark plug.
Page 14
NOTE: View is bottom of the unit
Figure
11
To Next Page
Loading...
Need help?
General
