To Next PageTo Next PageWhat to do if my Homewerks 7107-03HW is not clearing humidity from the room?
If your Homewerks Fan isn't clearing humidity, it might be due to insufficient airflow. Ensure a door or window is slightly open to allow airflow, as the fan needs adequate airflow to draw air out of the room. Also, verify that the CFM rating of the fan matches the square footage of your room.
Why is my Homewerks 7107-03HW Fan so loud?
If your Homewerks Fan seems louder than it should be, several factors could be the cause. First, ensure the fan is securely attached to the ceiling joists. The CFM rating might be too high for the room's square footage, so verify it matches. Also, check the damper to ensure it's opening and closing correctly; if damaged, contact Customer Service. Make sure there are no sharp bends in the duct within 18 inches of the fan discharge. Finally, use the recommended size ducting to reduce fan noise, ensuring the fan discharge isn't reduced to fit a smaller duct.
Crucial warnings for safe installation and operation of the ventilation fan.
Emphasizes turning off power before any servicing or cleaning.
Lists tools needed for assembly that are not supplied with the fan.
Lists optional tools that can aid in the installation process.
Warning about ensuring power is shut off before electrical work.
Verifying necessary power and neutral wires before installing.
Checking space for wiring and ductwork in the installation area.
Inspecting existing ductwork and wiring before proceeding with installation.
Planning for future maintenance access to the fan.
Recommends having a second person for easier installation.
Emphasizes adherence to all applicable electrical codes for wiring.
Warning against using aluminum wire with copper connections.
Guidelines for using the provided quick connector for wiring.
Clarifies conditions for reusing the wire connector.
Specifies the maximum temperature rating for wiring.
Details on insulation, ducting, and sealing for optimal installation.
Essential checks and preparations before commencing installation.
Instruction to remove any pre-existing fan unit.
Measures the ceiling opening for fan housing compatibility.
Guides cutting a new opening if no old fan exists.
Detaches the duct connector from the fan housing for installation.
Places the fan housing into the prepared ceiling opening.
Instructions for spacing of 12 inches between ceiling joists.
Instructions for spacing between 12 and 21.25 inches.
Instructions for spacing between 21 and 24 inches.
Securing suspension brackets to the fan housing.
Reattaching the duct connector to the fan housing.
Connecting house wires to the fan using quick connectors.
Connecting the duct to the fan housing and venting it outdoors.
Attaching the grille to the fan housing.
Caution to disconnect power before cleaning the fixture.
Instructions for cleaning the fan grille with a damp cloth.
Removing dust and dirt from the fan housing using a vacuum.
Reattaching the grille after cleaning.
Addresses causes and solutions for fan noise.
Troubleshooting problems with clearing room humidity.
General
