Need help?Do you have a question about the Honda 08E60-S9A-100 and is the answer not in the manual?
Operating Environment| operating temperature | –20°C to +60°C |
|---|---|
| range | Maximum 30 feet |
Battery| battery type | Lithium (# CR2025) |
|---|---|
| battery life | 1 year |
Weight and Dimensions| dimensions | 30.7 mm x 65 mm x 11.5 mm |
|---|---|
| net weight | 21 g |
Factors like buildings, high-power transmitters, and battery level affect range.
Avoid extreme temperatures and submerging the remote control in water.
Treat the remote as a sophisticated electronic device; avoid dropping or throwing.
Use the remote sparingly; low battery affects range; check and replace as needed.
Contact dealer for replacement and reprogramming to prevent lost remote operation.
Use a soft cloth for cleaning; do not use solvents like kerosene or thinner.
Locks doors and tailgate, flashes parking lights; second press confirms lock.
Unlocks driver door first, then all doors; flashes parking lights.
Push button for about two seconds to open the hatch glass on the tailgate.
Activates panic mode, sounding horn and flashing lights; deactivate with other buttons or ignition.
Indicates transmission and battery condition; dimming LED means battery replacement needed.
Instructions for replacing the remote's CR2025 lithium battery using a coin.
Steps 2-12 must be within 5 seconds; up to 3 remotes; turn key to OFF to complete.
Unlock the doors and tailgate to begin the programming sequence.
Turn the ignition key to the "ON" position to enter programming mode.
Press the LOCK or UNLOCK button on the remote transmitter.
Turn the ignition key to the "OFF" position to proceed.
Turn the ignition key back to the "ON" position to continue programming.
Press the LOCK or UNLOCK button on the remote control transmitter.
Turn the ignition key to the "OFF" position.
Turn the ignition key to the "ON" position.
Press the LOCK or UNLOCK button on the remote control transmitter.
Turn the ignition key to the "OFF" position.
Turn the ignition key to the "ON" position.
Press LOCK or UNLOCK; power door locks cycle to indicate programming mode.
Press LOCK button on each remote to store; door locks cycle to confirm entry.
To Next Page
