Using the Remote Engine Starter
Note: Remote Control Range (200 ft) depending on where you are, you may experience reduced range reception. See the
User’s Information Manual for more details.
Starting the Engine: 10-minute mode
1. Push the command button on the transmitter for
1 second or less, then push in the start button within
2 seconds.
2. The transmitter emits two rapid beeps, and sends a
signal to start the engine. After starting the engine, the
transmitter emits another sound, and the REMAINING
IDLING TIME indicator is shown on the display.
20-minute mode
Repeat step 1 to extend to 20 minutes.
NOTE
• Note that you cannot return the remote engine starter
system to the 10-minute mode after changing to the 20-
minute mode by operating the transmitter.
• The engine cannot start for 20 minutes even though you
stop the engine within 10 minutes after exceeding the
time to the 20-minute mode.
START
BUTTON
COMMAND
BUTTON
To Next Page
Loading...
