Honda 1998 VT750C User Manual

REAR WHEEL/BRAKE/SUSPENSION
, , SIDE COLLAR
.~.~~V1-,.~'~
Do not jack up the motorcycle using the oil filter.
REMOVAL
CAUTION:
Loosen the axle nut.
Loosen
the drive chain adjusters on both sides of
the swingarm. DRIVE CHAIN ADJUSTER.
Raise and
support the motorcycle using a hoist or
jack.
REAR WHEEL
Disconnect the brake rod from the brake arm.
Remove
the cotter pin, nut, washers and bolt from
the stopper arm on the brake panel.
Remove the axle
nut, right side collar and rear axle.
Side
the rear wheel forward and remove the drive
chain
from the driven sprocket.
Remove
the rear wheel.
INSPECTION
AXLE
Place
the axle in V-blocks and measure the runout.
Actual
runout is 1/2 the total indicator reading.
SERVICE LIMIT:
0.20 mm (0.008 in)
14-3

Honda 1998 VT750C Specifications

General

Displacement	745 cc
Bore x Stroke	79 mm x 76 mm
Compression Ratio	9.0:1
Ignition	CDI
Transmission	5-speed
Final Drive	Shaft
Rear Brakes	Drum
Front Tire	100/90-19
Rear Tire	140/90-15
Fuel System	Two 34mm constant-velocity carburetors
Front Suspension	41mm fork; 5.1 inches travel
Rear Suspension	Dual shocks
Front Brakes	Single disc
Seat Height	686 mm