The rear differential should be
drained and refilled with new fluid
accordingtothetimeanddistance
recommendations in the mainte-
nance schedule.
Check the fluid level with the rear
differential at normal operating
temperature and the vehicle on level
ground. Remove the differential fluid
filler bolt and washer, and carefully
feel inside the bolt hole with your
finger. The fluid level should be up
to the edge of the bolt hole. If it is
not, slowly add Honda Dual Pump
Fluid until it starts to run out of the
hole.
Put a new washer on the filler bolt,
then reinstall the filler bolt and
tighten it securely.
Use only Honda Dual Pump Fluid.
Do not use Automatic Transmission
Fluid (ATF).
4WD models only
Rear Differential Fluid
Maintenance
233
Correct
level
FILLER BOLT WASHER
０３／０３／０４ ２０：０１：２９ ３１ＳＣＶ６００ ０２３８
To Next Page
Loading...
