FUEL SYSTEM (Programmed Fuel
Injection)
MAP SENSOR REMOVAL/INSTALLA-
TlON
Remove the air cleaner housing (page 5
-
64).
Remove the screw and
MAP
sensor from the air
cleaner housing.
Installation is in the reverse order
of
removal.
IAT
SENSOR
REMOVAL/ INSTALLATION
Remove the air cleaner housing (page 5
-
64).
Remove the screws and
IAT
sensor from the air clean
-
er housing cover.
Installation is in the reverse order of removal.
SCREWS
ECT
SENSOR
Replace the
ECT
sensor while the
engine is
coid
Always
repiace a
seahng washer
w:th
a
new one
RE
M
OVA L/I
N
STALLATIO
N
Drain the coolant from the system (page 6
-
4).
Open and support the front end of the fuel tank (page
3
-
4).
Disconnect the ECT sensor connector from the sensor.
Remove the ECT sensor and sealing washer.
Install the new sealing washer and ECT sensor.
Tighten the ECT sensor to the specified torque.
TORQUE:
23
N-m
(2.3
kgfsm,
17
Ibfoft)
Connect the ECT sensor connector.
Fill
the cooling system with recommended coolant
(page 6
-
5).
5
-
82
To Next Page
