9. TRANSPORTING/STORAGE
1. Disconnect the fuel hose and install the cap on the engine fuel inlet.
Firmly close the fuel cap vent knob.
iL HOSE CONNECTOR
2. Loosen the carburetor drain screw, and drain the gasolineinto a
suitable container. After draining, tighten the drain screw.
6 Be careful not to spill fuel. Spilled fuel or fuel vapor may ignite. If
any fuel is spilled, make sure the area is dry before storing or
transporting the motor.
l Do not smoke or allow flames or sparks where fuel is drained or
stored.
piiEiq
In cold weather, to prevent ice from forming inside the water pump,
raise the motor out of the water. Disengage the emergency stop
switch clip from the engine stop switch and pull the recoil starter
several times to flush out the water.
44
To Next Page
