Maintenance Fundamentals
Pre-ride Inspection
To ensure safety, it is your responsibility to
perform a pre-ride inspection and make sure
that any problem you find is corrected. A pre-
ride inspection is a must, not only for safety, but
because having a breakdown, or even a flat tire,
can be a major inconvenience.
Check the following items before you get on
your motorcycle:
● Tire tread wear and air pressures are within
limits. 2 P. 56
● Lights, horn, and turn signals operate
normally.
● Check the condition of the drive chain.
Adjust slack and lubricate as needed. 2 P. 53
Check the following items if you are carrying a
passenger or cargo:
● Combined weight is within load limits.
2 P. 129
● Cargo is secured properly.
● Suspension is adjusted to suit load. 2 P. 87,
2 P. 88
Check the following items after you get on your
motorcycle:
● Throttle action moves smoothly without
binding. 2 P. 83
● Brake lever and pedal operate normally.
● Check the fuel level and refuel when
needed. 2 P. 13, 2 P. 37
● Engine stop switch functions properly.
2 P. 32
Check the following items at regular intervals:
● Oil level is between the upper and lower
level marks. 2 P. 65
● Brake fluid level is
Front: above the LWR level mark. 2 P. 72
Rear: between the UPPER and LOWER level
marks. 2 P. 72
● Engine coolant level is between the UPPER
and LOWER level marks. 2 P. 70
● Side stand functions properly. 2 P. 75
20160902115018_31MJWB100_enu_BOOK Page 49 Friday, September 02 2016 11:57:25 JST
Maintenance
46
To Next Page
Loading...
