7.
Apply a thin coat of engine oil to the
rubber seal of a new oil filter.
8.
Install the new oil filter and tighten.
Torque: 19 lbf·ft (26 N·m, 2.7 kgf·m)
9.
Install a new sealing washer onto the
drain bolt. Tighten the drain bolt.
Torque: 22 lbf·ft (30 N·m, 3.1 kgf·m)
10.
Fill the crankcase with the recommended
oil (2 P. 52, 2 P. 130) and install the oil fill
cap.
Required oil
When changing oil & engine oil
filter:
2.9 US qt (2.7 L)
When changing oil only:
2.6 US qt (2.5 L)
11.
Check the oil level. 2 P. 65
12.
Check that there are no oil leaks.
20160902115018_31MJWB100_enu_BOOK Page 71 Friday, September 02 2016 11:57:25 JST
Engine Oil u Changing Engine Oil & Filter
Maintenance
68
Rubber seal
Oil filter
To Next Page
Loading...
