189
uuOperating the Switches Around the Steering WheeluAuto High-Beam
You can turn the auto high-beam system off. If you want to turn the system off or
on, turn the ignition switch to ON (w
*1
, then carry out the following procedures
while the vehicle is stationary.
To turn the system off:
With the light switch is in AUTO, pull the lever
toward you and hold it for at least 40 seconds.
After the auto high-beam indicator light blinks
twice, release the lever.
To turn the system on:
With the light switch is in AUTO, pull the lever
toward you and hold it for at least 30 seconds.
After the auto high-beam indicator light blinks
once, release the lever.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
■
How to Turn Off the Auto High-Beam
1How to Turn Off the Auto High-Beam
If you turn the auto high-beam system off, the system
does not operate until you turn the system on.
Park in a safe place before turning the system off or
on.
21 CR-V PET ELP_MAP_HMIN_HCM-31TLA6400.book 189 ページ ２０２０年９月２日 水曜日 午後１時３５分
To Next Page
