62
Fig. K4-4
(l')
Switch case (Zl Throttle grip
13)
Lock
nut
@Upper
adjus1er
Fig. K4-5 <l)Throllle cable
Fig.
K4---6
(l') Throttle cable end (fl
Grip
pipe
Fig.
K4-7
@Rear
shock absorber
3.
Throttle
grip
The throttle grip
was
changed to a
new,
wind-in
type.
lnspedion
and adjustment
I. Check the free play
of
the throttle grip. It
should be 10-1
5°
of
the grip rotation.
2.
To
adjust, loosen the lock nut and tum the
upper adjuster
in
or
out
as necessary. Rota-
tion
of
the adjuster
in
direction (A) decreases
theplay,androtatingindircction{B)increases
the pla
y.
Tighten the lock nut after adjustment.
3.
Check the throttle cable for twisting
or
in-
terference
with adjacent parts; also for proper
routing, while turning the handlebar to each
extreme.
Repair or,
if
necessary, replace the cable with
Disassembly and assembly
1.
Loosen the screws securing the switch housing
to the handlebar. Separate the housing,
2.
Disconnect the throttle cable end from the
throttle grip pipe.
3.
Withdraw the throttle grip from the handlebar.
4. Assemble the throttle grip
in
the reverse order
or disassembly.
4.
Rear
shock
absorber
The rear shock absorber upper case, was discon,
tinucd.
To Next Page
