5.
Side s
tan
d
fhc
side stand was changcc to a new type with
a shock absorbing rubber pad.
The
scand must
be
inspected periodically
10
deter•
mine that it
is
in good condition.
Inspection
I. Check
the
entire stand assembly (side stand
bar. bracket and rubber) for installation,
dcfonnation
or
excessive damage.
2. Check the spring
fordamagcorothcrdefccts.
J. Check the side stand for proper return opera-
tion:
a. With the stand applied, tilt the machine
so that
it
clears the around.
b. Anach a spring scale
to
the lower end
of
the
stand
and
meas urc
the
force with
which the stand
is
returned to its original
position.
c. The stand condition
is
correct
if
the
measurement falls within 2-
3kg
(4.4-6.6
lbs.)
If the stand requires force exceeding the
above limit, this may
be
due 10 neglected
lubriaition, overtightened side stand pivot
bolt, worn stand bar
or
bracket,
or
exces-
sive tension. Repair as necessary.
4. Check the rubber pad for deterioration
or
When the rubber pad wear
is
so
CJ1.ccssive
that it
is
worn
to
the wear line, replace
it
with a new one.
Rubber repb.cement
I. Remove the 6
mm
bolt. Separate the rubber
from the bracket at the side stand.
2.
After installing the collar place a
new
rubber
pad
in
the bracket with the arrow mark facing
NOTE:
Use
a rubber pad
wi
th the mark "BELOW
2591bsONLY".
). Secure the rubber pad with !he 6
mm
bolt.
63
Fl&.
K4-8
Q:)Si
dc s!and bar iZISidc stand
$p
ri
n1
O)Rubber pad
(!)6mm
boll l!)Side
stand pivot
bolt
Fl&.
K4
-9 (l)S,de stand bar IZISprmg scale
GOOD
F"11.
K
4-
11 Q:)Rubber pad IZICollar
To Next Page
