22
OPERATION
STARTING THE ENGINE
To prevent a possible fire, keep the generator at least 3 feet (1 meter)
away from building walls and other equipment during operation. Do not
place flammable objects close to the engine.
• Operating this generator less than 3 feet (1 meter) from a building or
other obstruction can cause overheating and damage the generator.
• For proper cooling, allow at least 3 feet (1 meter) of empty space
above and around the generator.
Keep all cooling holes open and clear of debris, mud, water, etc.
Cooling holes are located on the side panel, the control panel, and
the bottom of the generator. If the cooling holes are blocked, the
generator may overheat and damage the engine, inverter, or
windings.
Refer to SAFE OPERATING PRECAUTIONS on page 21 and perform the
IS YOUR GENERATOR RE ADY TO GO? checks (see page 19).
Refer to the AC OPERATION (see page 28) for connecting loads to the
generator.
1.Make sure that all appliances connected to the generator are turned
off. The generator may be hard to start if a load is connected.
2.Turn the fuel filler cap vent lever to the ON position.
FUEL FILLER CAP VENT LEVER
ON
31Z398000.book 22 ページ ２０１３年８月１日 木曜日 午後４時３６分
To Next Page
Loading...
