Honda EB2500X - Starting and Stopping the Engine

STARTING THE ENGINE/STOPPING THE ENGINE
Starting the engine
1. Make sure that the AC circuit breaker is in the OFF position. The
generator may be hard to start if a load is connected.
2. Turn the fuel valve to the ON position.
3. Turn the choke lever to the CLOSE position.
4. Turn the engine switch to the ON position.
5. Pull the starter grip lightly until resistance is felt, then pull briskly.
Do not allow the starter grip to snap back. Return it slowly by hand.
6. Turn the choke lever to the OPEN position as the engine warms up.
Stopping the engine
In an emergency:
l.To stop the engine in an emergency, move the engine switch to the
OFF position.
In normal use:
1. Turn the AC circuit breaker to the OFF position.
2. Move the engine switch to the OFF position.
3. Turn the fuel valve to the OFF position.
25