48
TRANSPORTING/STORAGE
TRANSPORTING
STORAGE
STORAGE TIME RECOMMENDED SERVICE PROCEDURE TO
PREVENT HARD STARTING
If the generator has been used, allow it cool for at least 15 minutes
before loading the generator on the transport vehicle. A hot engine
and exhaust system can burn you and can ignite some material.
To prevent fuel spillage when transporting, the generator should be
secured upright in its normal operating position, with the engine
switch OFF and the fuel tank cap vent lever turned fully
counterclockwise to the ‘‘OFF’’position.
Before storing the unit for an extended period:
1. Be sure the storage area is free of excessive humidity and dust.
2. Service according to the table below:
Take care not to drop or strike the generator when transporting. Do not
place heavy objects on the generator.
Use gasoline conditioners that are formulated to extend storage
life. Follow the instructions included with the conditioner.
Contact your authorized Honda generator dealer for conditioner
recommendations.
Less than 1 month
1 to 2 months
2 to 6 months
6 months or more
No preparation required
Fill with fresh gasoline and add gasoline
conditioner *. Run the engine for 10 minutes
to use up the non-treated gasoline.
Fill with fresh gasoline and add gasoline
conditioner *. Run the engine for 10 minutes
to use up the non-treated gasoline.
Or drain the gasoline. (page 49).
Drain the gasoline. (page 49).
Remove the spark plug. Put a tablespoon of
engine oil into the cylinder. Turn the engine
slowly with the starter grip to distribute the
oil. Reinstall the spark plug.
Change the engine oil. (page 40).
After removal from storage, fill with fresh
gasoline before starting.
*
05/06/20 14:33:04 31ZT3604_049
To Next Page
Loading...
Need help?
General
