Honda GX390UT2 - Crankshaft Runout

CRANKCASE
CRANKSHAFT RUNOUT
Set the crankshaft on V-blocks and measure the runout
using a dial indicator.
If the measured runout is more than the service limit,
replace the crankshaft (page 13-5).
SERVICE LIMIT: 0.1 mm (0.003 in)
16 mm
(0.6 in)
GX240/270:
16 mm
(0.6 in)
GX340/390:
17 mm
(0.7 in)
L/P/W TYPE ONLY:
MEASURE POINT
GX240/270
L TYPE:
31 mm (1.2 in)
GX340/390
L TYPE:
36 mm (1.4 in)
P TYPE:
32 mm (1.3 in)
W TYPE:
24 mm (0.9 in)
EXCEPT L/P/W TYPE:
MEASURE POINT
gx240ut2_gx270ut2_gx340ut2_gx390ut2