uuJump Startingu
612
Once your vehicle's engine has started, remove the jumper cables in the following
order.
1. Disconnect the jumper cable from your vehicle's stud bolt.
2. Disconnect the other end of the jumper cable from the booster battery -
terminal.
3. Disconnect the jumper cable from your vehicle's 12-volt battery + terminal.
4. Disconnect the other end of the jumper cable from the booster battery +
terminal.
Have your vehicle inspected by a nearby service station or a dealer.
■
What to Do After the Engine Starts
1What to Do After the Engine Starts
The indicators for the Adaptive Cruise Control (ACC)
with Low Speed Follow, Vehicle Stability Assist (VSA)
System, VSA OFF, Low Tyre Pressure/Deflation
Warning System and Safety Support Indicator
(Amber) may come on along with a message in the
gauge when you turn the power system on after
reconnecting the 12-volt battery.
Drive a short distance at more than 20 km/h (12
mph). The indicator should go off. If it does not, have
your vehicle checked by a dealer.
21 JAZZ HYBRID SSS-32TZA6000.book 612 ページ ２０２０年１月２９日 水曜日 午前１０時３２分
To Next Page
Loading...
