△
The spare tire is stored
underneath the rear cargo area.
Remove the plastic cover on the
cargo area lining to access the
shaft for the spare tire hoist.
Put the wheel nut wrench on the
hoist shaft. Turn the wrench
counterclockwise to lower the
spare tire to the ground. Keep
turning the wheel wrench to
create slack in the cable.
Remove the bracket from the
spare tire.
Placethejackunderthejacking
point nearest the tire you need to
change. It is pointed to by a
mark molded into the underside of
the body. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the jacking point tab is
restinginthejacknotch.
Loosen each wheel nut 1/2 turn
with the wheel wrench.
8.
7.
6.5. 9.
Changing a Flat Tire
Taking Care of the Unexpected
198
SPARETIREWRENCH
BRACKET
JACKING POINT
To Next Page
