#
Headlight Bulb
1.
Remove the headlight case. 2 P. 51
2.
Disconnect the connector.
3.
Remove the rubber dust cover.
4.
Slightly press down on the pin and turn it
clockwise until it releases from the bulb
housing.
5.
Remove the bulb.
6.
Install a new bulb and the parts in the
reverse order of removal.
u Install the rubber dust cover with its
TOP mark facing up.
Do not touch the glass surface with your
fingers. If you touch the bulb with your bare
hands, clean it with a cloth moistened with
alcohol.
20181207113539_32KVMC000_eng_BOOK Page 86 Friday, December 07 2018 11:40:26 JST
Electrical Trouble u Burned-out Light Bulb
Troubleshooting
83
Continued
Connector Rubber dust cover
Bulb
TOP mark
Pin
To Next Page
Loading...
