2
16. A loose fit between the AC outlet (receptacle)
and plug may cause overheating and a
distortion of the plug. Contact a qualified
electrician to replace loose or worn outlet.
17. DO NOT operate any fan with a damaged
cord or plug. Discard fan or return to an
authorized service facility for examination
and/or repair.
18. DO NOT run fan cord under carpeting.
DO NOT cover cord with throw rugs, runners,
or similar coverings. DO NOT route cord
under furniture or appliances. Arrange cord
away from traffic areas and where it will not
be a tripping hazard.
WARNING: To Reduce The Risk of Fire or
Electric Shock, DO NOT Use This Fan With
Any SolidState Speed Control Device,
other than the one supplied.
This fan features a fused safety plug which is designed to cut off electric current to the fan if an electrical
fault occurs. Please see below for more information on how to properly use your fan and replace the safety
plug fuse, if needed.
FUSED SAFETY PLUG - FOR US ONLY
USER SERVICING INSTRUCTIONS
• If your fan loses power and you suspect that the fuse on your fan has
blown, grasp plug and remove from the receptacle or other outlet
device. DO NOT unplug by pulling on cord.
• Slide fuse cover, located on the top of the plug, towards the prongs
of the plug. (Fig. 1)
• Carefully remove the blown fuse and snap a new fuse into place.
To Reduce the Risk of Fire, replace fuse only with 2.5 Amp,
125 volt fuse. Fully close the fuse door by sliding back into
place. (Fig. 2) Discard the blown fuse. The plug should now
be ready for normal use.
• To Reduce the Risk of Fire, DO NOT replace attached plug. The
plug contains a safety device (fuse) that should not be removed.
Discard product if the attachment plug is damaged.
• If you need further information on how or when to replace the fuse in
the safety plug, please contact our Consumer Relations department at
18004770457. You may also visit our website at:
www.HoneywellPluggedIn.com.
Fig. 1
Fig. 2
To Next Page
Loading...
Need help?
General
