4
REMOTE CONTROL BATTERY INSTALLATION/
REPLACEMENT INSTRUCTIONS
A. Remove battery door by sliding downward in direction
of arrow (Fig. 9).
B. Insert 2 AAA batteries into the remote following the
directional guides in the recessed slots. Batteries are
not included.
C. Replace battery door by sliding upward opposite of arrow
direction until door snaps in place.
NOTE: DO NOT MIX OLD AND NEW BATTERIES. DO NOT MIX
ALKALINE, STANDARD (CARBONZINC), OR RECHARGEABLE
(NICKELCADMIUM) BATTERIES.
SEE RECYCLERS IN YOUR AREA FOR PROPER DISPOSAL OF BATTERIES.
REMOTE CONTROL OPERATION
ON/OFF
Press the Power button ( ) once to turn the fan on. Press the Power button a second time to turn the
fan off.
SPEED CONTROL
The fan will automatically start on “Sleep” speed when initially turned on. To adjust the speed up or down,
press the Fan Speed button (
) repeatedly to increase level.
OSCILLATION
To activate the Oscillation feature, press the Oscillation button ( ) once.
Press the Oscillation button again to turn the Oscillation feature off.
REMOTE CONTROL STORAGE
When it is not in use, the remote control may be stored in the recessed
area located behind the controls (Fig. 10).
REMOTE CONTROL
Fig. 9
Fig. 10
To Next Page
Loading...
Need help?
General
