Setting up your thermostat
Setting up your programmable thermostat is easy. It is preprogrammed and ready to go as soon as it
is installed and registered.
1. Install your thermostat.
2. Connect your home Wi-Fi network.
3. Register online for remote access.
Before you begin, you may want to watch a brief installation video. Use the QR Code® at the front of
this guide, or go to honeywellhome.com/support
Connecting to your Wi-Fi network
To complete this process, you must have a wireless device connected to your home wireless network.
Any of these device types will work:
Tablet (recommended)
Laptop (recommended)
Smartphone
If you get stuck… at any point in this procedure, restart the thermostat by removing the thermostat
from the wallplate, wait for 10 seconds, and snap it back onto the wallplate. Go to Step 1 in this
procedure.
View the Wi-Fi Enrollment video at honeywellhome.com/wifi-thermostat
1. Connect to your thermostat.1a. Make sure the thermostat displays Wi-Fi Setup.1b. On the
wireless device (laptop, tablet, smartphone), view the list of available Wi-Fi networks.
1c. Connect to the network called NewThermostat_123456 (the number will vary).
To Next Page
Loading...
Need help?
General
