22 Operating Manual Touch operating module for MB/MB-Secure
5. Operating without / with code
The Touch operating module can be programmed as follows depending on the application:
- For one zone; display with code; operation with code
- For one zone; display without code; operation with code
- For one zone; display without code; operation without code
- For several zones; display with code; operation with code
- For several zones; display without code; operation with code
- For several zones; display without code; operation without code
Depending on this programming, it is necessary to enter a code before further operation or before the
system status is displayed.
- Enter code and
-Acknowledge by touching "OK".
The operating functions are distributed
over 3 different authorization levels.
The desired function can only be selected
if the corresponding authorization level
(4-digit code, 5-digit code or 6-digit code)
has been entered.
The following overview provides information on which operating functions of the intrusion control
panels 561-MB100.10 / MB48 / HB48.10 / MB24 / HB24 may require the entry of a code according to
the programming.
1
1
1
1
1
1
5.1 Code input
5.2 Overview of levels of authorization
The levels of authorization mentioned above are not relevant for the
MB256 plus. In this control panel the individual operating functions are allocated to the
operating code with 1 to 8 digits).
Ask the installer for further information on the operating code (number of digits and
released functions).
intrusion control panel
561-
3
2
1
9
6
5
8
4
7
OK
0
CLR
----------
Operation code
Please enter code
- View detector groups - Clear detector groups - External disabling/enabling
- Start macro - Internal disable detector groups - Clear tamper detector groups
- Internal arming - Activate walk test - Change date and time
- settings - View event memory
- Slideshow - Internal disarming
Code 4-digit Code 5-digit Code 6-digit
Touch module
To Next Page
Loading...
Need help?
General
