To Next Page

To Previous Page

1. Push the safe door to the closed position and turn the knob counter clockwise to the left (Figure 1).

2. Enter the preset primary factory code “1 5 9” followed by “E” key into the keypad. If the correct code

is entered, the green LED will light up (Figure 2).

3. The knob can then be turned clockwise to the right to open (Figure 3).

NOTE: You have approximately 5 seconds to open the safe. If you wait any longer, the safe will

re-lock and you must re-enter the code to open the safe.

4. To lock, close safe door and turn knob counter clockwies to the left (Figure 4).

PROGRAMMING NEW USER CODE

TESTING DIGITAL LOCK

Figure 1

Figure 2

Figure 3

Figure 4

Green LED

Green LED Yellow LED

Beep

1. Open door using the factory preset code of 159 followed by the “E” key (Figure 1).

2. Remove the battery cover to access the red reset button located on the inside of the battery

compartment. Press the red reset button and the yellow LED will light up (Figure 2).

3. Enter a new 3-8 digit Primary user code followed by the “E” key. Press “C” to clear entry if wrong

digit is entered (Figure 3).

4. Safe will beep and yellow light will turn o (Figure 4).

5. You can now close and lock the safe door and your new User Code is now active.

NOTE: The factory pre-set code will not work after a new pass code is programmed.

Figure 4

Honeywell 5005 User Manual

Other manuals for Honeywell 5005