EN-3
Minimum Supply Pressures at the inlet of compressed air supply hose:
Supply Pressure in bars (psi)
DAVK-0003E, 0004E
DMAK-0023E, 0024E
DAWK-4001E, 4011E
5.3 bars
(77 psi)
5.4 bars
(79 psi)
5.5 bars
(80 psi)
4.5 bars (61 psi)
4.6 bars (63 psi)
4.7 bars (64 psi)
• Maximum Supply Hose Length 10 metres.
• For DAVK-0001E and DMAK-0021E, if the warning whistle sounds at any time during the operation of the
auxiliary tool or spraygun, increase the input pressure until it stops. This ensures that there is sufficient
air reaching the headpiece and that your safety is maintained.
TECHNICAL INFORMATION
EN14594:2005 (Light Duty Class A)
Nominal Protection Factors
Class 3 = 200 DAWK models
Class 4 = 2,000 DAVK & DMAK Models
Visor: Chemical resistant
Impact resistant
Manufacturer’s Minimum Design Flow Rate
Maximum Flow Rate
4.5 bars (61 psi) to 7.0 bars (102 psi)
Maximum Operating Temperature
Replace after 1,000 hours, or
If odour is detected inside headpiece
PROTECTION FACTORS
An assigned Protection Factor (APF) of 40 means that the respirator can be used in areas of contamination up to 40 X the Workplace Exposure Limit.
In other geographical areas, please refer to national or regional regulations or guidelines which modify the value of the protection factor
that you are allowed to use when selecting respiratory protection.
AIRVISOR RESPIRATOR SYSTEMS
Airvisor 2 Paint Spraying Kit
Airvisor 2 Industrial Kit
Airvisor 2 MV Paint Spraying Kit
Airvisor 2 MV Chemical Kit
Airvisor 2 MV Industrial Kit
Airvisor 2 FV-Series Welding Kit
Airvisor 2 W-Series Welding Kit
Airvisor 2 Paint Spraying Kit double action connector
Airvisor 2 Chemical Kit double action connector
Airvisor 2 Industrial Kit double action connector
Airvisor 2 MV Paint Spraying Kit double action connector
Airvisor 2 MV Chemical Kit double action connector
Airvisor 2 MV Industrial Kit double action connector
Airvisor 2 FV-Series Welding Kit double action connector
Airvisor 2 W-Series Welding Kit double action connector
To Next Page
Loading...
