Honeywell BENDIX/KING KY 96A - Page 23

B KY 96A, KY 97A
Rev 4, Apr 2003 IM 006-00674-0004.dwd Page 2-9
FIGURE 2-4 Molex Terminal and Tools (Sheet 2 of 3)
Holding the hand crimpers as shown, release the crimper's ratchet pawl ar.d open by squeezing tightly
on the handles, and then releasing pressure.
HAND CRIMPER
PN 071-06041-0000
MOLEX P/N 6115
Close crimpers until ratchet begins to engage. Then insert the terminal into the jaws from the back
side. (See Figures at bottom of page) For 24 to 3CAWG wire, it will be necessary to start the crimp
in
jaw A and then complete it in jaw B.
JAW TERMINAL WIRE SIZE
INSULATION RANGE
A
030-011 07-0030 18 TO 24 AWG .110 TO .055
B 030-01107-0030 24 TO 30 AWG .055 TO .030
/~WIRE STOP
Terminal is in correct position when insJlation tabs are flush with outside face of cri,mp jaws.