B KY 96A, KY 97A
Rev 4, Apr 2003 IM 006-00674-0004.dwd Page 1-4
1.4 UNITS AND ACCESSORIES SUPPLIED
NOTE: Not all configurations listed below are currently available, consult Bendix/
King Equipment Catalog for further information.
1.4.A. KY 96A VHF Comm Transceiver, P/N 064-1052-XX, which is configured in the
following versions:
1.4.B. KY 97A VHF Comm Transceiver, P/N 064-01051-00XX, which is configured in
the following versions:
SPURIOUS RESPONSES AND CROSS
MODULATION PRODUCTS:
At least 80 dB down.
INTERCOM INPUT: When the mic is connected to the intercom input both
the receiver and mic audio appears at the audio output.
100 mVrms of mic audio into 500 ohms is required for
100 mW output.
TABLE 1-2 KY 96A Configurations
PART NUMBER
RECEIVER
SELECTIVITY
AUDIO OUTPUT FREQUENCY RANGE
064-1052-10 25 kHz 500 ohm headphone 118.000 to 135.975 MHz
064-1052-11 50 kHz 500 ohm headphone 118.000 to 135.975 MHz
064-1052-30 25 kHz 500 ohm headphone 118.000 to 136.975 MHz
064-1052-31 50 kHz 500 ohm headphone 118.000 to 136.975 MHz
064-1052-50 25 kHz 8 W into 4 ohms 118.000 to 135.975 MHz
064-1052-51 50 kHz 8 W into 4 ohms 118.000 to 135.975 MHz
064-1052-60 25 kHz 8 W into 4 ohms 118.000 to 136.975 MHz
064-1052-61 50 kHz 8 W into 4 ohms 118.000 to 136.975 MHz
064-1052-70* 25 kHz 8 W into 4 ohms 118.000 to 136.975 MHz
*Crown Series Unit
TABLE 1-1 Technical Characteristics
SPECIFICATION CHARACTERISTIC
To Next Page
Loading...
