LYNX LON PROGRAMMABLE, VAV/UNITARY CONTROLLERS – PRODUCT DATA
EN0Z-0957GE51 R0615
5
211
49105
159 149
159
21
DEPTH = 57
12
3
4
56789009
11111111121
12345678
PANEL MOUNTING
HOLE (4 X 4.5)
Fig. 4. Duct mounting, dimensions in mm
(CLLYVL0000AS, CLLYVL4022AS, and CLLYVL6436AS)
146
128
1234
5
678901234
5
67890
2222222222
333333333
4
1234
5
678 1
11111111
234
5
6709
262
211
47
164
159
11
DEPTH = 57
PANEL MOUNTING
HOLE (4 X 4.5)
Fig. 5. Duct mounting – controller and actuator,
dimensions in mm (CLLYVL6436AS, only)
122 122
105 105
159 159149 149
11
11
22
3
4
567890
11
11
22
3
4
567890
PANEL MOUNTING
HOLE (4 X 4.5)
PANEL MOUNTING
HOLE (4 X 4.5)
12
33
44
5678900
11111 2222211
12
33
44
5678900
11111 2222211
DEPTH = 57DEPTH = 57
Fig. 6. Panel mounting, dimensions in mm
(CLLYUL1012S, CLLYUL4024S, and CLLYVL4024NS,
only; CLLYUL4024S, and CLLYVL4024NS shown)
Panel Mounting
The controller enclosure is constructed of a plastic base plate
and a plastic factory-snap-on cover.
12
3
4
567890
12
3
4
567890
22222222223333333334
1234
5
678901234
5
67890
22222222223333333334
12
3
4
5678
1234
5
678
1
11111111
2
3
4
56709
1
11111111
234
5
6709
146
139
139
128
128
164
164
174
CLLYUL6438S
CLLYVL6438NS
DEPTH = 57
DEPTH = 57
Fig. 7. Panel mounting, dimensions in mm
(CLLYVL6438NS and CLLYUL6438S)
NOTE: The controller is designed so that the cover does
not need to be removed from the base plate for
either mounting or wiring.
The controller mounts using four screws inserted through the
corners of the base plate. Fasten securely with four screws.
The controller can be mounted in any orientation. Ventilation
openings are designed into the cover to allow proper heat
dissipation, regardless of the mounting orientation.
DIN Rail Mounting (Models without Actuator)
To mount the CLLYUL1012S, CLLYUL4024S, and
CLLYUL6438S or CLLYVL6438NS controller onto a DIN rail,
see Fig. 8 and perform the following steps:
1. Holding the controller with its top tilted in towards the DIN
rail, hook the two top tabs on the back of the controller
onto the top of the DIN rail.
2. Push down and in to snap the two bottom flex connectors
of the controller onto the DIN rail.
To Next Page
Loading...
Need help?
General
